DFR
Hobbs entry is now made from the Hobbs meter icons above the LEGS section of the DFR.

A Delete icon has replaced the Clear All button that was in the header on Scratchpad and manually created flights. It is now available for all flights, and will be disabled once a flight is in progress.
Note also there is no longer a paperclip icon for viewing documents, or a schedule icon for viewing the flight schedule. Instead, a new Docs tab for both viewing the schedule and viewing and managing documents has been added to the right of the MSG tab.

The interface for entering approaches has changed slightly, eliminating extra button pushes.

When entering Block time, you can now tap the arrows to reset the total Day block time to match the Block In and Block Out.

When adding a new load to the LOADS section of the DFR, the interface for selecting the route is now more intuitive, allowing you to select the departure and arrival points instead of selecting from a lengthy list.

Nav
A Toggle Leg Complete button replaces the Delete Leg button. Tapping it will complete the highlighted leg (without adding actual reserve fuel). Tapping it when any completed leg is highlighted will un-complete the leg and any following legs.

Destination Waypoints
Tap on a route pair in the Leg column to open the destination selection list so you can edit the route.
Note: En route waypoints can no longer be added from the destination select page. To add en route waypoints, from the Nav tab, tap on the Route/Complete column.
Tap the red X to eliminate a destination from the route.

When inserting a destination, the new waypoint will be added after the previously highlighted leg.

Change waypoint order by clicking a waypoint and dragging it to the desired position.

For organizations that have had the full list of waypoints hidden, the full list now shows.

En Route Waypoints
Tap on a leg in the Route/Complete column to open the route waypoint selection window to edit the route.

Select from the list of waypoints, or search for the desired waypoint(s) to insert as a route between your departure and destination airports.

Or tap the GPS Routes button to select from routes created and stored in FlightSpan™ Ops.

W&B
When copying a load, you now copy to rather than copy from a leg.
First highlight the leg with the desired load, then tap the Copy Config/Load To button to duplicate the load and/or configuration, and add it to one or more flight legs.

Switch the Copy Load as well? switch to off to just copy the configuration.

When exporting a load to the DFR, the route will default to the selected tab. Tap the Quick Select arrow next to the desired route pair if necessary.

Tap on the departure point and the destination if the load will continue to a subsequent destination, tap Done, then continue adding the load as in the legacy version.

Some aircraft have had the layout changed slightly.

Runway Charts
The Custom tab is now labeled CUST, and when a runway is selected, it will always display the runway name instead of CHNG.

The NRST tab is now labeled with the name of the runway once a chart has been selected.

You can now pinch and zoom Runway Chart images.

Map
You can now pinch to zoom on the map.
Use the Declutter button if airports are too close together to only display the ones with the longest runways

If you move the map off center, a Recenter button appears under the Track Up / North Up buttons. Tap to recenter on your current position.

If you want to navigate to an en route waypoint, tap the Sequence button which appears if the route is other than Direct.

Then select the desired route segment.

The After Takeoff checklist now only dismisses automatically after the Checklist has been armed by sending the trip manifest. The armed condition is indicated by the Checklist button turning blue.

MSG
The Message tab functionality is completely new. See the Message Tab documentation for details.
Docs
The Documents tab is a new addition to the EFB. See the Documents Tab documentation for details.
Settings
The settings interface has also been completely redesigned. See the Settings documentation for details.